OK, I'm having trouble with another quad on another post, this is a different subject. I booted up the computer in the morning and ran a cc3d that was already flying through the setup wizard to calibrate it to new motors and ESC. No prob with that, went right through, still having trouble with that quad, so I started working on a different one. I put an new cc3d and reciever on a zmr250, dys 2205 2300 motors. Dys 30a ESC. This was later in the day, run it through the setup wizard, it goes a little slower, takes a few min to reboot after I selected sbus connection, but all seemed fine until I get to the save the settings, i click save, the status bar says "preparing mixer settings" fills with 1/3 blue boxes and freezes, the letters turn red and that's as far as it'll go. So is it a computer issue, program issue or flight controller? Everything works good until it tries to save, then nothing.