[sherm6178]

could really use a little help if possible. I had this revo flashed with raceflight installed in my qav180 not in case. Went to tighten down wiring and when I plugged it back  in this is all it does. Won't connect to any gcs unless in dfu mode. I can flash bootloaders both rf and lp/op. On op/lp firmware it just sets and never ending boot loop and this is rf bl installed. Any suggestions would be greatly appreciated. http://www.rcgroups.com/forums/showthread.php?p=34742356


Sent from my iPad using Tapatalk

[hwh]

If it's not a hardware problem then the instructions and firmware in this thread https://forum.librepilot.org/index.php?topic=208.0 should bring it back up in LP.   The resurrection firmware is necessary because other firmware formats data areas differently.  It reformats the data areas.

[sherm6178]

I believe I already tried that one but just to make sure I will try again then report back thank you

[sherm6178]

tried the link again and same as before. i think i shorted something when i was messing with the wires. i just dont know were to look  for the dead component. any help would be greatly appreciated 

[hwh]

Normally I'd expect if it ran well enough to load firmware through DFU it should be good enough to boot up so I really don't have any suggestions.  If the resurrection firmware doesn't get it running there probably is some hardware problem but I don't know what.

The full schematics of the revo are in the repository at https://bitbucket.org/librepilot/librepilot/src/a71fb62395fd40e7f5693ac5ea0d78c706ec73af/hardware/Production/OpenPilot%20Revolution/?at=next  maybe that will help.