I have a pitch Gimbal using an analog servo that for the most part works fine. Using a CC3D ..Nothing fancy in the setup. The problem is that when the pitch the craft up or down the servo will move as it should BUT hold it in that position for a few seconds, and the servo will creep back to the neutral position. It does not matter what angle of pitch it will move to where it should be, but then it slowly goes back to neutral. Pitching the craft up and down fast works, do it slow and the servo gets all out of whack until it stays level for a few seconds to "re-set itself. I have tried swapping it with a digital servo just to make sure it wasn't that particular one and have tested a few different frequencies with no help. I use it for FPV flying so it is very important that it maintains horizon. Thanks for any assistance!