[sated]

I have ran thru the wizard several times, and still when i save and disconnect everything nothing happens. I plug in the battery and try to arm the system but nothing. Just a slow blinking blue status light. I have tried looking up the status codes but im just bombarded by forum links :/. really looking for some insight, If youre down to for me to screen share through skype or teamveiwer that would be preferred. But overall I'm just stuck.

[f5soh]

Hi, welcome.

Can you post your config file ?
File > Export UAV Settings

If you can't arm the is something wrong (safety first) and you may take a look  at SystemHealth panel.

[sated]

Turnigy 9x8C V2 receiver aswell

[f5soh]

There is nothing wrong in this config file.

You choose "Yaw left" for arming, there is no errors.

[sated]

Yea thats what I thought. However when I unplug everything and then just use the battery the there is not response from the transmitter to motors.

[f5soh]

Redo the transmitter wizard, just to be sure all is right.

I notice you skipped the flight mode switch, in this case you cannot see the sticks movements on screen... (16.09 issue)

You reversed the Yaw and Pitch, maybe something wrong in this part.
Take a look here as a workaround for correct input setup
https://forum.librepilot.org/index.php?topic=3156.msg21834#msg21834

You can also double check the stick movements using the stick panel in PFD.
https://librepilot.atlassian.net/wiki/display/LPDOC/PFD#PFD-RcInputpanel

[sated]

Alright I ran thru the transmitter wizard again and set up my fail safe to the gear switch (two positions) on my turnigy 9x.
https://gyazo.com/34f8ece91ad1064e44f792dd316e966d