[ArthurB]

Awesome!! After doing the esc calibration in the output tab it works! Thank you f5soh!
Maybe there is a problem in the esc calibration with the wizard?

There is just something weird : when I do the transmitter wizard, the roll is put to channel 1 and pitch to channel 2, but when I disconnect the board and use the transmitter, if I push forward of backward (ch.2) the servos move opposite (roll), and if I push left or right, the servos move in the same direction (pitch).
I have to invert channels 1 and 2 in the input tab to attribute 1 to roll and 2 to pitch. Then the servos move OK.

Weird isn't?

[ArthurB]

My bad! I failed the servos configuration! Forgot to look at "up" and "down" pointers ^^'

Every thing is perfect. Hope this topics helps other people. Thank you both