Op-link mini can't connect Revo
« on: March 12, 2019, 06:14:44 pm »
I stopped trying to configure my quadcopter last year.
Now i'm trying again updating the firmware but  i'm still on the ground.

Software
Linux Debian 9
Librepilot Sep 29 2018 15:42

Frame: Realacc (zmr250)
FC: Open pilot revo
Oplink 433Mhz
Distributor: happymodel
Esc: Racestar 30A
Motors: Racestar BR2307s 2200KV Green Edition
Gps: GPS Module Ublox NEO - M8N
Battery: 3S 1350
Radio: no radio https://librepilot.atlassian.net/wiki/spaces/LPDOC/pages/14221378/Control+vehicle+using+joystick

Can you help me?

 

Re: Op-link mini can't connect Revo
« Reply #1 on: March 13, 2019, 01:57:31 pm »
I'posting a few configuration screenshot

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Op-link mini can't connect Revo
« Reply #2 on: March 13, 2019, 02:38:07 pm »
Hi,

You do not need the "DataAndControl", simply "Data" is sufficient in your case.
Apply "100000" for the Air Data Rate in both sides.
Copy the DeviceID from Oplink (something with xxC1988E) into the Revo/Receiver config > CoordinatorID to make connection first.

Re: Op-link mini can't connect Revo
« Reply #3 on: March 13, 2019, 06:50:03 pm »
I made the corrections you seggested and now PFD moves when i move the quadcopter.

Thank you very much.

Now i should understand why the arm switch in the controller panel doesen't arm the motors ( in a new topic).