CC3D does not save the setting.
« on: January 08, 2019, 03:09:19 pm »
Hello everyone. I'm turning to the forum experts, so I have problems with the configuration change in my CC3D.
I can update firmware without problems, but, configuration does not.
I posted some pictures to see someone can help me.

Re: CC3D does not save the setting.
« Reply #1 on: January 08, 2019, 04:45:53 pm »
Go to Firmware page.   Does it say "BL Version: 3" or "BL Version: 4"?  If 3 then you need to update your bootloader.  After that you MUST reflash firmwareusing Manual method (instructions on same page):
https://librepilot.atlassian.net/wiki/spaces/LPDOC/pages/5669026/Firmware+Tab#FirmwareTab-Updatebootloader

Else you must Erase Settings.  Try this:
- unplug board (no USB or power)
- go to Firmware and press Rescue
- plug board in to USB
- press Erase Settings and follow the instructions to Press OK
- wait for at least a minute after pressing OK (FlightTime will start counting again and let it count up to at least 60)

Here is a thread where other users had a similar problem and @f5soh posted special firmware to try to help.
https://forum.librepilot.org/index.php?topic=4492.0

Please post back here to let us know what fixed it.  I have seen this problem a lot lately and don't know if problem was fixed or user just gave up.

Re: CC3D does not save the setting.
« Reply #2 on: January 08, 2019, 07:47:36 pm »
Cliff, thanks for the help. I'm with "BL V4". I tried these procedures described in the topic that you indicated, but, it does not work.
Is it an irreversible problem?

Re: CC3D does not save the setting.
« Reply #3 on: January 08, 2019, 07:52:01 pm »
... then you need to update your bootloader.  After that you MUST reflash firmware using Manual method (instructions on same page):
https://librepilot.atlassian.net/wiki/spaces/LPDOC/pages/5669026/Firmware+Tab#FirmwareTab-Updatebootloader

Did you reflash firmware after doing BL and before the Erase Settings procedure?

Re: CC3D does not save the setting.
« Reply #4 on: January 09, 2019, 02:08:56 am »
Hello Cliff. I did a different procedure through the CF that returned the functionality of the board.
I will register with pictures and send later.