Revo with Bluetooth
« on: July 13, 2018, 09:02:11 am »
Hi all!

Can someone point me out a tutorial on using revo as combridge to set the BT device up?

 There are alot using FTDI..
and I dont have one FDTI, nor do I want to install FTDI drivers.

ComBridge I want to use! ;)

Thanks
Cheers,
Rui





Re: Revo with Bluetooth
« Reply #1 on: July 13, 2018, 10:59:04 am »
If I understand it correctly one has to:

1) have the Revo communicating with GCS.
2) Change the hardware settings to VPC and ComBridge. (on the Hardware tab)
3) Save and Unplug Revo. (Force reboot)
4) Connect the BT and Power (batt + bec) to Revo and plug it back. (boot)
5) Open a Putty (or equivelent) session to the com port.

What I don't know is:
Am I supposed to leave the GCS running or not?
I couldn't find the Baud rate settings... It's not on the Hardware tab.
Do we set the baud rate to be the same as expected on the BT device?

Rui



Re: Revo with Bluetooth
« Reply #2 on: July 13, 2018, 01:27:23 pm »
Why not use Oplink instead?  ???

Re: Revo with Bluetooth
« Reply #3 on: July 14, 2018, 06:27:05 am »
Because I have an BT among my stuff already.

Re: Revo with Bluetooth
« Reply #4 on: July 15, 2018, 09:50:37 am »
It's working.

Some un install device (on windows) a couple of times...
And keep the USB and Main Port as Telemetry the whole time!

Next step, try and tune the stabilized flying modes.

Cheers,
Rui

Re: Revo with Bluetooth
« Reply #5 on: July 15, 2018, 05:10:34 pm »
If you can hover without crashing and it has a "Revo class" FC, then you can use AutoTune flight mode.
https://librepilot.atlassian.net/wiki/spaces/LPDOC/pages/25657377/AutoTune