Revo and IBUS
« on: June 12, 2018, 10:14:26 am »
Good Morning

I’ve just completed my first build, a ZMR 250 frame, running a Revolution board. It is operating using PPM as i thought my FlySky X6B receiver supported SBUS which it doesn’t. I know the CC3D (at the time of purchasing) didn’t support IBUS, and there’s no option for it in LibrePilot 15.09, however, the IBUS option now appears when updated to 16.09.

So my question is, Will the Revolution now support IBUS, or is this just an option that wont work and has just appeared in LibrePilot?

I’m fine with PPM, but if IBUS could be an option, it would make the wiring a little neater  :)

Cheers

Re: Revo and IBUS
« Reply #1 on: June 12, 2018, 10:10:34 pm »
I have not used it, but I believe it is supposed to work.