Stack Error
« on: April 03, 2018, 05:03:12 pm »
Hi!
With the last firmware uploaded (git hash b8239e3c) on my CC3D brushed board, I have a red "stack error".
It happens randomly but it is very annoying because I have to reboot 2/3 times the board and hoping that the error disappears...

Do you know how can handle it?

Thanks

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Stack Error
« Reply #1 on: April 03, 2018, 06:39:35 pm »
Can you post your config file ?
The stack error can be debugged after enabled the DIAG_TASKS and recompiling the firmware for CC3D.

Re: Stack Error
« Reply #2 on: April 03, 2018, 08:51:48 pm »
Do you have a MinimOSD OSD that uses MSP telemetry?  I think I recall that is one common cause.  If I am right, then for CC3D, it is best to use MinOpOSD OSD firmware that handles OP/LP telemetry instead of trying to run 2 different protocols.

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Stack Error
« Reply #3 on: April 03, 2018, 09:50:56 pm »
There is no issue with MSP on CC3D.
The issue is you cannot run MSP + GPS at same time, where you run out of memory.

Re: Stack Error
« Reply #4 on: April 04, 2018, 11:49:27 am »
Attached you can find my configuration file...
Is it possible to disable all the modules that I don't need?

jdl

  • ***
  • 246
Re: Stack Error
« Reply #5 on: April 04, 2018, 12:40:23 pm »
I've noticed the same problem.

I mitigated the occurence of this issue by increasing period or just disabling (set to "0") in Data Objects | ...... | Metadata | Flight Telemetry Update Period = 0 for all objects that I do not need for MinOpOSD telemetry.

Now I get the Stack Error very, very seldom.