Lahiru

  • *
  • 8
  • Build . Fly . Crash . REPEAT
Do anyone tried doing 3d with a cc3d board ?
« on: March 11, 2018, 09:43:32 am »
I'm just curios to see how cc3d holding up a 3d flight. if someone have tried anything let us know . (thanks)

karla

  • ****
  • 444
Re: Do anyone tried doing 3d with a cc3d board ?
« Reply #1 on: March 13, 2018, 03:39:46 am »
Hi, Lahiru,
Yes, have a trex450 and two trex250s all using the small CC3D Atom boards (same size as RevoNano).
https://forum.librepilot.org/index.php?topic=2892.msg20125#msg20125
Flying in Rate or VBar modes and Axislock for the tail.
Works fine.
Have not been out with them for a while though.

I think this user, posted some 3D video here: https://forum.librepilot.org/index.php?topic=3379.msg23056#msg23056
« Last Edit: March 13, 2018, 03:46:35 am by karla »

Lahiru

  • *
  • 8
  • Build . Fly . Crash . REPEAT
Re: Do anyone tried doing 3d with a cc3d board ?
« Reply #2 on: March 13, 2018, 06:39:37 pm »
Hello karla,
Thanks for the info. how those 250s fly ? is it easy to tune pid values ! i missed a lot in here .... thanks again

karla

  • ****
  • 444
Re: Do anyone tried doing 3d with a cc3d board ?
« Reply #3 on: March 14, 2018, 12:33:14 am »
They fly nicely but are a bit more difficult than flying the larger 450, that one is a pure pleasure.
One of them I have not got tuned fully to my satisfaction yet.
Its not easy to tune, but as long as you don't have vibrations its just a matter of time and patience to get it done.
I think Dave did a handy little Troubleshooting guide for 250 heli:
https://forum.librepilot.org/index.php?topic=1689.msg12284#msg12284
-Karl

I really hope user gongtao0607, continues the development he did on Vbar.