Sparky2 and WS2812B 8 Leds board from Matek?
« on: February 05, 2018, 06:26:55 pm »
Hi all
I've got a Sparky2 FC running the 16.09 librepilot firmware in a custom built quad. I've also bought a WS2812B led board from Matek and would like to use it with this quad.
The thing is that I did not find any instructions for the connections and configuration.
Can anyone give me some pointers to install and configure this led board? Is it even possible
Thanks.
MA
« Last Edit: February 05, 2018, 06:36:35 pm by micheleamerica »

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Sparky2 and WS2812B 8 Leds board from Matek?
« Reply #1 on: February 05, 2018, 07:33:03 pm »
Take a look here : Setup WS281x Led

Re: Sparky2 and WS2812B 8 Leds board from Matek?
« Reply #2 on: February 13, 2018, 09:41:14 pm »
Thanks... the leds do light up now  :)
Nonetheless I'm having a hard time finding the correspondance between what I'm seeing and the sequences as mentioned in the wiki pages.
Is there an issue if there are only 8 leds instead of the 10 mentioned in the wiki?
Are there other parameters (configurable and not something requiring a recompilation of everything) that may help in properly configuring the leds?
Thanks
MA

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Sparky2 and WS2812B 8 Leds board from Matek?
« Reply #3 on: February 13, 2018, 10:11:14 pm »
There is no issue with 8 leds, you can use only one led as well.
« Last Edit: February 13, 2018, 10:34:53 pm by f5soh »

Re: Sparky2 and WS2812B 8 Leds board from Matek?
« Reply #4 on: February 15, 2018, 04:34:38 pm »
Thank you.