[cartf155]

Hi every one.
I am trying to set up my CC3D controller with LibrePilot.
I have conected ibus throught the main port, flexi port, and the principal port (PWM) and no one run...
I am using wizart setup , and in te point of ESC configuration, the BEEPS confirmation never sounds

Anyone has had the same problem?
I really need help.

[f5soh]

Hi, welcome.

The only way to connect IBus receiver to the CC3D is using the Flexiport.

Configure the flexiport as Ibus and reboot the board, check the receiver activity found in Input tab and move sticks.

If you have init/no beeps issues with your Esc, simply revert the Output config banks as PWM-490Hz instead of PWMSync