Newbie here.... Need help with a T8FB and CC3D controller
« on: January 12, 2018, 10:20:17 am »
Hi all,

My apologies if this has been addresses already as I am new here. I am having challenges with a Sky Hero Anakin drone using a CC3D Flight Controller and RadioLink T8FB Transmitter on S-Bus. I am obviously using LibrePilot on this controller. For some reason, when I try and 'arm' the drone after setting Yaw Right as the arming option, it does not allow the drone to arm when I use Yaw Right. It just sits there.

The only way I can get the drone to arm is to set it to Arm Always which is obviously not ideal.

I was wondering if anyone could give me some advice on where to start looking to see where the challenge is?

Thanks

Ian

f5soh

  • *****
  • 4219
    • LibrePilot
Re: Newbie here.... Need help with a T8FB and CC3D controller
« Reply #1 on: January 12, 2018, 06:32:52 pm »
If board cannot arm there is a good reason, most of the time something wrong in configuration and a alarm in SystemHealth.

Please post post your config file.
File > Export UAV Settings...