[demigodspecial]

Hello. I want to use my camera. I ticked Enable CameraStab. Mode in Gimbal tab. But i cant activate channel 5 and 6 in output tab.  I did the steps in this document:
https://librepilot.atlassian.net/wiki/display/LPDOC/Camera+Stabilisation+Configuration
Can anyone help me?

[utoedter]

Min, neutral, max to normal values, 1000,1500,2000 ?


Rettet den Luftraum, esst mehr Vögel.

[TheOtherCliff]

Your min/neutral/max is 1000/1000/1000 and it should be 1000/1500/2000
Start by fixing that and pressing Save.

[demigodspecial]

But i cant change neatural value. Its grey.

[f5soh]

Set min/max as described in Wiki page.
Maybe reboot board and finally adjust neutral value.

[demigodspecial]

Its ok now but channel 5 and 6 still grey. Any ideas how can i fix this?

[TheOtherCliff]

Sorry, those are no longer grayed out. 

What happens when you plug servos in to #5 and #6?  I forget, but the FC may need to be in attitude mode and armed.

What about outputs 1 -> 4?  What else is this FC being used for?

[demigodspecial]

Sorry, those are no longer grayed out. 

What happens when you plug servos in to #5 and #6?  I forget, but the FC may need to be in attitude mode and armed.

What about outputs 1 -> 4?  What else is this FC being used for?

Well the idea is two outputs for my contra motor. And the other channels for the camera but ı want to use them for to move flaps +-45degrees. Dont know if its work. Just bought this fc a couple days ago .It dosent matter 5,6 or another two outputs. But still i dont know why 5,6 still now active. I did everthing viki says :/.