« previous next »
Pages: [1]
*

rc54321

  • *
  • 5
DaveApplemotors
« on: June 07, 2017, 05:52:32 pm »
Thank for dropping by RC Groups and checking my CopterX cc3d thread.

Ric...
Logged
*

rc54321

  • *
  • 5
Re: DaveApplemotors
« Reply #1 on: June 07, 2017, 10:46:43 pm »
Hi Dave,

Do you know if there are any compatibility between LibrePilot  and any of the F3 or F4 flight controller boards? Have anyone you know used one on a heli?  Just starting to explore more options at a low cost that can get a heli up and flying. The F1 cc3d has been great and I am starting to migrate from cc3d to F3 or F4 board on my multirotor, that is why I asked.

Ric...
Logged
*

TheOtherCliff

  • *****
  • 4304
Re: DaveApplemotors
« Reply #2 on: June 08, 2017, 12:22:31 am »
LP 1609 currently supports Nano, Revo and Sparky2 (all F4 boards).

'next' has preliminary support for several F3 boards.
Logged
*

rc54321

  • *
  • 5
Re: DaveApplemotors
« Reply #3 on: June 08, 2017, 04:38:04 pm »
That is good news. I haven't done much research yet or used lp16.09 much. Not sure what extras I am hoping for in the heli. But would love to try one in a heli for sure. Thanks TheOtherCliff.
Logged
*

TheOtherCliff

  • *****
  • 4304
Re: DaveApplemotors
« Reply #4 on: June 08, 2017, 04:56:26 pm »
It's my understanding that heli is a manual setup process with several users exchanging ideas, work flows, and uav (setup) files here in this part of the forum.
Logged
Pages: [1]
« previous next »