[utoedter]

Hello all,

Ive changed the FC from my Eachine Racer from the genuine CC3D which was installed by default to a Mini Revolution Board. I did all the calibration stuff, used the same output settings (490Hz) but if i fly in complementary mode, the quad twitches. Its not serious , you can control the quad without problems, but its visible and hearable. With the normal CC3D board the quad flies very stable.  Increasing the gyro noise filtering to a very high value of 0.4 reduced the problem, but it still exists. Any hints are welcome.

Udo

[utoedter]

Problem solved, other as stated. one output channel used 50Hz update rate, the 3 others 490Hz. Sometimes im blind. 

[eRacerTaranisPlus]

you are lucky (probably "smart" is a very term) because I can't even get my Revolution board/Eachine250 Racer to work. I cant seem to get the mag and gps calibration to work. Any tips? Thanks.