paul0

  • *
  • 4
Black rhino and stick response
« on: April 14, 2017, 10:51:38 am »
Hi guys

Not had my 250 out much lately but have a issue. Was running version before latest two updates 15. Or something. Everything is good. Good low down stick response even with slight expo added. Since the update to black rhino I don't get very good control. There is expo added but no more than before.

Is there something I've missed? Another new setting

When I updated I did a screen shot of rates etc. Then did a clean install. So config should be good. I haven't tried to remove complete expo. But I can't see that being a problem. Or is it

Cheers
Paul

Re: Black rhino and stick response
« Reply #1 on: April 14, 2017, 03:07:22 pm »
Are you saying that control at low throttle is not as good?  Maybe needs PID tuning or TPA?

paul0

  • *
  • 4
Re: Black rhino and stick response
« Reply #2 on: April 14, 2017, 06:05:07 pm »
Nope throttle is all good. Good power just roll. Pitch and jaw no real input until 40 percent throw. Like expo but tbh it's very flat so worse

Re: Black rhino and stick response
« Reply #3 on: April 14, 2017, 09:50:13 pm »
It may be that you have a deadband set too high or maybe extreme expo in the transmitter settings?

paul0

  • *
  • 4
Re: Black rhino and stick response
« Reply #4 on: April 14, 2017, 10:14:06 pm »
I'm sure deadband is 0 and expo on control isn't set. There is expo on the settings on quad. But it's just what I had set on older firmware.

If I flashed older firmware and used identical settings it would lean and yaw a little with slight stick movement but won't on latest firmware. It's strange.

I did try version before black rhino but had issues like this and just rolled back without issues but I can't use always stabilised as option isn't possible.

Forgot to say I'm using cc3d flight board without baro just gyros

Paul

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Black rhino and stick response
« Reply #5 on: April 14, 2017, 10:33:36 pm »
Quote
There is expo on the settings on quad. But it's just what I had set on older firmware.

Using 16.09 you should set half value from 15.09 for similar expo behavior, as mentioned in Notes here :
https://librepilot.atlassian.net/wiki/display/LPDOC/Downloads


paul0

  • *
  • 4
Re: Black rhino and stick response
« Reply #6 on: April 14, 2017, 11:41:22 pm »
Aha that's what you get when you don't read release notes very well.

I will try with no expo.

Thank you for clearing that up :)