Re: OSD
« Reply #15 on: December 20, 2015, 11:20:09 pm »
I think he was talking about Micro MinimOSD. I has a Batt 1 and a Batt 2 pin. In the setup if you want to display Batt A voltage, then connect battery voltage to Batt 1 pin on the board, the voltage counts down to zero just after boot. If you remove power from Batt 1 pin and attach it to Batt 2 pin, without changing anything in the display setup, it will display correctly. Don't know why this is, but I have read about several people having this problem.

AKQuad

  • *
  • 1
Re: OSD
« Reply #16 on: April 17, 2016, 05:13:19 am »
HELP! I'm a MAC user. I have been trying to flash a mini OSD with firmware. Thus far I've been unable to solve the problem. Can anyone do it for me? I'm using a Revolution Mini flight board. I'm open to suggestions.