[Jonh]

Has anyone used one of these Hobbyking R617XL  cppm Receivers

I have just purchased one of these RX and  it is supplied with a 8 Pin JST SH cable connector (Pins 1,2 and 3 are cabled up)
This cable will fit the CC3D Board 8 Pin JST receiver port !!!

Am I correct in saying  that I will have to remove the Pin 3 connection on this cable and move it the Pin 8 position so that I can use PPM_PIN8+Oneshot ?

(How easy is it to relocate a Pin from one of these really small connectors ??)



 

[f5soh]

You can move the signal wire to the pin8.
Move carefully the small plastic piece using a scalpel, remove wire and insert the wire to the new place.