Motors will not spin after completing GCS setup
« on: February 14, 2017, 04:15:46 am »
I purchased a Quanum Outlaw 180 so I could have something to fly right away, no time to build some frames that I bought. I know, that's my problem right there.

Ran the whole setup in GCS, ran the arming sequence and nothing.

The Outlaw has an all in one esc, pdb, and cc3d flight controller, and the board is very difficult to see. It has a solid green led and a flashing red led, blinks about every 1 second. I run the arming sequence, it beeps, some leds flash, but can't tell the colors or the blink sequence.

Have a fully charged battery pack, and also running an Frsky X8R rx.

Someone please help me!!!

Thanks,
Ray

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Motors will not spin after completing GCS setup
« Reply #1 on: February 14, 2017, 10:03:37 am »
Hi,

Can you see if the arming is done while connected to the computer ?

Post your config file, maybe helps. File > Export UAV settings.

Re: Motors will not spin after completing GCS setup
« Reply #2 on: February 14, 2017, 08:10:45 pm »
If you remember setting the arming stick position, maybe you forgot to press Save after that?

Check it on Configuration -> Input -> ArmingSettings