Newbie-Motor starts while in vehicle setup wizard
« on: December 20, 2016, 10:48:49 pm »
I'm trying to configure my CC3D controller with a used ESC and motor using the standard fixed wing setup in the setup wizard. When I get to the motor calibration, the motor does nothing until I click start and move the adjustment slider, then it starts spinning full throttle. As I move the slider to the right I can then adjust the speed but it seems backwards. Then when I click to stop the motor it spins up full throttle again and I have to disconnect battery. I've tried a different controller and have checked my connections but continue to have issues. Any suggestions would help.

P.S.  The ESC and motor work fine in the unit they were taken out of (custom commercial unit).

Re: Newbie-Motor starts while in vehicle setup wizard
« Reply #1 on: December 21, 2016, 12:37:03 am »
It sounds like the ESC signal direction is reversed.  Swap the min and max numbers (for that channel on the output page) and try again.