Question regarding Voltage Display MICRO MinimOSD /KV
« on: November 17, 2016, 05:46:10 pm »
Hey guys, I'm having some trouble with getting the voltage to display with the current OSD I have. I've tried running wires (20 gauge) from the PDB to both the BAT1 & BAT2 pads but I'm still getting a false reading on the display. I'm not sure which firmware is running on the board as my brother originally set it up, but would flashing it to the firmware supplied on the librepilot wiki page maybe solve this issue? Sorry if this question has been asked before but I'm really getting tired of this as I've spent so much time trying to get it to work, and with there being so many combo's of OSD's and flight controllers it gets difficult researching.

Thanks in advance!  ;)
« Last Edit: November 17, 2016, 05:49:38 pm by Choking_Hazard »

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Question regarding Voltage Display MICRO MinimOSD /KV
« Reply #1 on: November 17, 2016, 06:36:04 pm »
If you use LP firmware you should use one of the firmware from the wiki page.
https://librepilot.atlassian.net/wiki/display/LPDOC/MinOPOSD+setup#MinOPOSDsetup-Downloadsdownloads

Look at description and download what you need.

Re: Question regarding Voltage Display MICRO MinimOSD /KV
« Reply #2 on: November 17, 2016, 07:03:36 pm »
Thanks for the response bud, I'll give the firmware swop a try. I'll probably have to try swop the wire again as well to BAT2 as it's sitting on BAT1 currently.