Alle

  • *
  • 2
ACRO+ - CPU warning
« on: August 26, 2016, 07:49:32 pm »
Hi all,

I configured three flight modes on my CC3D board:
- Attitude, Flight mode 1, on bank 1
- Rate trainer, Flight mode 2, on bank 1
- Acro+, Flight mode 3, on bank 3

If I select the flight mode 1 and 2, I do not have any warning and the cpu usage is more or less 82%.
If I select the flight mode 3 (Acro+), an orange warning appear in the System Health table.

I have enabled the TPS for bank 1 and bank 3 and I do not use any board rotation module.

Is it normal that this warning appear?
Should I disable the TPS or is there any other solution?

I suppose, that it is not safe to fly with the orange warning, right?

Thank you.
Ale

Re: ACRO+ - CPU warning
« Reply #1 on: August 27, 2016, 04:14:37 am »
I recall that the coming release has some performance improvements, but don't hold me to that.  Export your current settings and try a recent "next" to see if it is any better?

Other than that if it were me I would first look at the exact CPU percentage I have in the worst case, then try disabling some options to get the CPU green, and if all else fails, if I had a safe place to fly it, and the model wasn't too expensive, and the CPU was not too bad, I would try it cautiously.

Alle

  • *
  • 2
Re: ACRO+ - CPU warning
« Reply #2 on: August 27, 2016, 08:35:58 am »
Ok, Thank you.
I will give a try to a recent "next".
I thought that there were no problem with the Acro+ mode for the cpu usage or at least that this mode was using less cpu than the attitude flight mode.
I will try to disabile at first some options, if any other than tps.
Thank you