Stabilisation Reversed - only yaw correct
« on: July 31, 2016, 09:41:37 pm »
Hi all Librepilots,

Trying to set up my CC3D. Everything set up ok on GSC (so I think). Saved and exit. CC3D board mounted correct orientation in planr.

When I connect the battery to my model all the stabilisation is reversed except for Yaw. So If the plane yaws then the FC corrects correctly. Yay!

But if the plane pitches or rolls then the CC3D FC doesn't correct but goes the wrong way. I.e rol will roll in the same direction and pitch will pitch in the same direction.

CC3D board is mounted facing forward correct orientation etc.

It seems I need to "reverse" some of the stabilisation so the it corrects external forces.

Help, please.

Regards,

Hoender.

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Stabilisation Reversed - only yaw correct
« Reply #1 on: July 31, 2016, 10:57:38 pm »
Hi, welcome.

If you follow the Vehicle wizard and look the small green arrow that show the ailerons movement, you should be able to reverse the servo direction if needed.
Same with Radio Wizard, stick movement on screen should match how you move the stick in real.

If all matches, there is no issue.
« Last Edit: July 31, 2016, 11:00:43 pm by f5soh »

Re: Stabilisation Reversed - only yaw correct
« Reply #2 on: August 01, 2016, 08:06:24 am »
Thanks,

Radio setup is correct.

I did not pay too much attention to those green arrows on vehicle set up wizard!  Will keep an eye out for them and reverse as necessary.


Re: Stabilisation Reversed - only yaw correct
« Reply #3 on: August 01, 2016, 09:14:44 pm »
Thanks, reversed where green arrows were not reflecting the control surfaces.

Everything seems to correct in the right direction now.