Revo & GPS.. nearly working, completely stumped
« on: June 08, 2016, 10:35:30 pm »
[First post. I've lurked forever.]

I'm so close to having this working but I'm now completely stumped. Everything is green, GCS map shows everything that it should be showing, I can even (kinda) fly in GPS modes. I'm so close..

If I place the quad down on a level surface it'll show as level in GCS. If I rotate/yaw 90/270deg (in either direction) it un-levels by a few degrees. Return to 0/180, everything is level. I've re-calibrated everything a few times (even thermal once).

Attaching some pics, hopefully they make sense.

Ideas?

Revo + M8N

f5soh

  • *****
  • 4572
    • LibrePilot
Re: Revo & GPS.. nearly working, completely stumped
« Reply #1 on: June 08, 2016, 11:36:23 pm »
If you understand all sensor data (13 inputs) are used to determine the vehicle attitude using INS13, your result is pretty good.
https://librepilot.atlassian.net/wiki/display/LPDOC/INS13+-+GPS+Navigation

This also implies all alarms still Green while vehicle is in flight, especially Mag alarm. (no disturbed Mag)

Re: Revo & GPS.. nearly working, completely stumped
« Reply #2 on: June 09, 2016, 03:36:21 pm »
Back to the drawing board I think.. mag goes to yellow/red when I hit the throttle.

Ty!

hwh

  • *
  • 1018
Re: Revo & GPS.. nearly working, completely stumped
« Reply #3 on: June 09, 2016, 04:36:13 pm »
On most small quads the revo's internal mag is unusable.  The revo is just too close to the wiring. You should probably install an external mag, either in a gps or one of the tiny mag only boards.