Se64s

  • *
  • 1
REVO+MINOPOSD -> No data
« on: April 10, 2016, 09:53:15 am »
Hi everyone.

I configured mi osd following  instructions posted on wiki (https://librepilot.atlassian.net/wiki/display/LPDOC/MinOPOSD+setup) and all works fine.
But when i unplug the usb cable, al telemetry data stop appearing on screen.

Firmware on Revo: 15.09
Firmware on MinOPOSD: LP_All_From_Revo2303.hex

Thanks for any help.

jferfre

  • *
  • 22
Re: REVO+MINOPOSD -> No data
« Reply #1 on: May 22, 2016, 07:59:51 pm »
Hi.

If you have your telemetry sent to ground station, this is your issue.

I have had this in the past. To solve this, just put the telemetry power emission to 0mW in Librepilot software.

That's it. I hope it helps

^_Pepe_^

hwh

  • *
  • 1018
Re: REVO+MINOPOSD -> No data
« Reply #2 on: May 22, 2016, 10:13:40 pm »
If you have the oplink in the revo set to on (power not zero) then telemetry won't work on the OSD unless the oplink is connected to the one on the ground.   As long as the oplinks are talking to each other you should have OSD telemetry available.

jferfre's solution of set the power to zero is necessary if the oplink on the ground isn't connected to the revo one.