[hwh]

If it's positioned correctly in the case.  The mag chip orientation is:

[Xviews]

same problem like user "heubie" and others with the AuxMag is not recognized with battery power up. Any solution without USB ?

[[email protected]]

Ok the mag is in the same position of the boardmag i ask the roll pitch yaw value is 0 0 and 0?or i need to change it?.thank you

[hwh]

If the chip is on the top of the board and facing the way the picture shows all the settings for aux mag should be 0.

[f5soh]

For users with AuxMag issues, update your build:

git pull and rebuild
You should see "GCS 15.09+r596-g61ce3d6" on top of window.

Go to firmware tab:
- Rescue
- Open firmware you just downloaded from this post
- Flash

Test with a basic Auxmag config using setup wizard if I2C alarm still.

Updated firmware for testing and determine the delay needed
https://forum.librepilot.org/index.php?topic=1110.msg10186#msg10186

[f5soh]

@Ariele Please post a screenshot of your Magnetometer tab while all values are set to 0, and both mag calibrated and without alarm of course.

[Xviews]

Okay thx i will test it

Update

Nice its working and windows build working too Best day
No Problems with mag

For users with AuxMag issues, update your build:

git pull and rebuild
You should see "GCS 15.09+r596-g61ce3d6" on top of window.

Go to firmware tab:
- Rescue
- Open firmware you just downloaded from this post
- Flash

Test with a basic Auxmag config using setup wizard if I2C alarm still.

[Jhinta]

For users with AuxMag issues, update your build:

git pull and rebuild
You should see "GCS 15.09+r596-g61ce3d6" on top of window.

Go to firmware tab:
- Rescue
- Open firmware you just downloaded from this post
- Flash

Test with a basic Auxmag config using setup wizard if I2C alarm still.

is this the same as the build in firmware or do i need this file?
  just do as told

[Jhinta]

having problems, 
i2c does connect but , my quad doesnt keep its settings ,, like input switchs back to pwm where i have ppm, also random gps and i2c gets disabled

[f5soh]

Be sure the GCS version is GCS 15.09+r596-g61ce3d6

Erase settings

[Jhinta]

it is ,
anyway ,, when connecting bat -> gps/i2c/reciver setting all disable
usb only -> all seems fine.
just strange, seems like a half boot, normal boot , led shoel be blinging like 5 sec then steady , now it is blue 4x slow -> then boot up -> blue -> yello-> blue , etc  slowly

edit , this is random ,,  got it working ,, but it failes more then it fully boots.

[f5soh]

Try this one, just in case.

[Jhinta]

Boot error . this is with bat connected . usb only is fine( 10% of the time is good)

Verstuurd vanaf mijn LG-D855 met Tapatalk

[Jhinta]

  v1 seem beter in booting

[Jhinta]

this is what happends
https://drive.google.com/file/d/0B2mgUknSz_EfQzF6ckx3cl9ueW8/view?usp=sharing