"Level" off by a few degrees
« on: March 16, 2016, 11:30:54 pm »
Hopefully you can see the picture clear enough to show things are not perfectly level, for some reason.  Would being off by that much be a problem?  It is sitting on a flat surface with some double side tape underneath.  If I move the cc3d around a bit, just itself, I can be even on the horizon, so maybe I need to do a little shim on one side though it is not noticeably lopsided. 

What do you think? Thanks!

Edit: I notice in the LP screen the horizon lines bounces up and down slightly.  I may not understand this screen.

f5soh

  • *****
  • 4572
    • LibrePilot
Re: "Level" off by a few degrees
« Reply #1 on: March 17, 2016, 12:20:37 am »
You can redo the level calibration on Attitude tab.

The only reference is the flight test, you can adjust level if needed using the Virtual attitude rotation.

Re: "Level" off by a few degrees
« Reply #2 on: March 17, 2016, 12:47:53 am »
-1 on Virtual roll seemed to get it centered.  Not sure what you mean by "The only reference is the flight test".  Gather you mean putting it up in the air ?