[mrmcnoob]

i cant get passed the first section with moving the throttle stick. when I go to manual mode I have full tx signal. transmitter and receiver are bound correctly. an error says "there is something with throttle range please redo calibration and move ALL STICKS, throttle included" please help ive been stuck on this for a week. this is my first build. its a Chinese clone 250. please and thank you

[cato]

Hi mrmcnoob,

first, welcome to librepilot.

I am a bit lost about the information you gave us so far. For a start,
- which controller and which firmware are you using (CC3D or Revo, Openpilot or Librepilot) ?
- Did you run vehicle setup wizard and transmitter setup wizard?
- "Chinese clone 250" is very unspecific. Could you tell us a bit more about your quad?

[mrmcnoob]

Yes it is a qav250 clone. Cc3d with the librepilot setup. 20amp esc with mt2204 2300kv cheerwing motors. I ran the setup just fine calibrated the motors and updated the board. But when i get to the rc setup i cant get passed the first step which is the throttle. My TX only reads 1 bar. If i go to manual rc setup my tx has full bars.

[mrmcnoob]

Vehicle setup wizard i can het through just fine its just the first step of the transmitter setup wizard i can't get passed.

[soulreaper]

Are you using pwm, ppm, or sbus?  It's weird that the throttle is the only one giving you problems.