f5soh

  • *****
  • 4572
    • LibrePilot
Re: op link binding problem
« Reply #15 on: March 13, 2016, 07:40:05 pm »
Post screenshots of booth sides

armond

  • *
  • 5
Re: op link binding problem
« Reply #16 on: March 14, 2016, 06:10:52 pm »
Sure. Here the one which is selected as coordinator is oplink connected to frsky taranis.
The problem occurs during the Input channel configuration, when I replicate movements on the controller. It seems like it doesn't send any signal.

f5soh

  • *****
  • 4572
    • LibrePilot
Re: op link binding problem
« Reply #17 on: March 14, 2016, 06:25:16 pm »
OPLink connected to taranis : Set flexiport to PPM, the one used for PPM input

On Revo : Check the PPM check box

If the link is already active, nothing more to do. Reboot all and go to Transmitter wizard.

armond

  • *
  • 5
Re: op link binding problem
« Reply #18 on: March 14, 2016, 06:47:56 pm »
Do you mean to check PPM only? In this way the telemetry will be disabled, right?
And when in Transmitter wizard.. should the Revo or OPLink be connected via usb?

f5soh

  • *****
  • 4572
    • LibrePilot
Re: op link binding problem
« Reply #19 on: March 14, 2016, 06:49:29 pm »
No, there is "PPM only" and "PPM" while revo is connected.

You need "PPM" checked !

armond

  • *
  • 5
Re: op link binding problem
« Reply #20 on: March 14, 2016, 06:58:39 pm »
Thanks, dude! This made it work! Brilliant  :)

jtrout19

  • ****
  • 334
Re: op link binding problem
« Reply #21 on: March 17, 2016, 05:00:21 am »
How is the control when sent through the Oplink. I am currently using a Frsky Module. Why did you choose to go with the Oplink. Are there any pros or cons to going with an Oplink over a regular TX/RX or vis versa?