[fboriero]

Hi everybody!
I want to build a micro-copter using a brushed CC3D
http://www.banggood.com/Eachine-CC3D-32bits-Brushed-Flight-Control-Board-Based-On-Openpilot-For-DIY-Micro-FPV-Frame-p-1087646.html?rmmds=cart

I followed this topic https://forum.librepilot.org/index.php?topic=1597.msg11639#msg11639 but still when I connect battery pack all motors start to spin very fast.

Someone could help me?

Bests
Fabrizio

[xfce]

Hi everybody!
I want to build a micro-copter using a brushed CC3D
http://www.banggood.com/Eachine-CC3D-32bits-Brushed-Flight-Control-Board-Based-On-Openpilot-For-DIY-Micro-FPV-Frame-p-1087646.html?rmmds=cart

I followed this topic https://forum.librepilot.org/index.php?topic=1597.msg11639#msg11639 but still when I connect battery pack all motors start to spin very fast.

Someone could help me?

Bests
Fabrizio

you must configure in the system setting page, don't use the output setup page

[fboriero]

Thanks a lot for your reply!

I did as you said, attached there is my configuration file...

Fabrizio

[uncommongrafx]

Great and helpful thread!
  

[fboriero]

Was a stupid mistake! I have inverted polarity of main power port... (I don't know how the board can still running    )