[MrPickles2009]

TL;DR: In librepilot I can't save when in configuration settings for my quadcopter.

I recently programmed my CC3D board for the first time. I successfully was able to get my quad in the air but when I went to make modifications to the settings on the cc3d it wouldn't let me save. The save button would have a red x next to the save button instead of a green check mark. I moused over the save button and it says: "Be sure to set the Neutral position on all sliders before sending! Applies and Saves all settings to SD"

Anyone know how to fix this so I can save my adjustments to the CC3D?

[f5soh]

Hi,

When armed you cannot save the settings.
Maybe you are using the "Always armed" setting.
You should use another parameter for arming. (Switch or stick movement)

[MrPickles2009]

Thank you so much! I can't believe I didn't think of this.