[weepop]

OK after sorting out my quad I decided I would like to have a go at fitting a CC3D to one of my fixed wings.
Should be a doddle compared to quad.. mistake
I bought a new CC3d from Amazon for £8.90 and attempted to fit it to my electric Wot4, with no success.

Can any body tell me the connexions required.
I am using a DX8 with a AR8000 receiver.

The wires to the receiver plug on my CC3d do not make sense to me:-

From the left facing socket:-

1  black..............................3w plug
2  red.................................3w plug
3  blue
4  yellow
5  white...............................3w plug
6  green
7  blue
8  yellow                                all others single way plug

Can any one shed any light on this . I am starting to suspect above plug is wrongly wired

Thanks David

[f5soh]

1-2 are ok for Gnd / 5v
But generally the white wire is at pin3.

If you plan to connect all wires to receiver (PWM), the wiring is not so important and the Tx wizard detect every input the right way when you move sticks as asked.