[ccameselle]

Hello everyone,

I have a problem with my CC3D. It is not recognizing the AUX 1 or AUX 2. I have done the transmitter wizard 3 times and nothing. I have the same set up in 4 more quads and they work fine. The funny thing on this one is that the Yaw is picked up by channel 5 and not channel 4. I have re wire the receiver and the CC3D also 3 times. To make sure that the wire are in the correct order and still nothing. Any help with this will be greatly appreciated

[Daxo]

Radio?

[ccameselle]

 
Turnigy i10 with a FlySky FS-iA6 Receiver 6CH

[Daxo]

Don't have any experience with that radio but, when you connect the battery, is your  receiver on? Led lights up on cc3d and receiver?

[f5soh]

Try monitoring the receiver activity moving one stick/switch at once.

Go to UAVOBrowser and search for ReceiverActivity in Data side.


The only variable between setups is the CC3D board ? Same radio profile and receiver ?

[TheOtherCliff]

For future reference, this is typically caused by the transmitter needing some configuration to even output the switch onto a channel. 

Much less frequently from PWM RC inputs without a wire connected for that channel, or from other protocols with a higher channel than is supported.