[myflyer]

Hi everyone, had a low and fast crash two plugs on the receiver came un plugged. Replaced plugs in proper location. Now when I plug in the battery I get the beeps and lights on board and receiver. But it will not arm with the  transmitter. I even tried a different receiver. I also checked the  continuity of the wires from the receiver to the FC

[onecooler]

Hi!

Check your board status and transmitter inputs in GCS. Start troubleshooting from connecting to GCS is the "best LP practices".

-K.

[myflyer]

Thank you, I had it hooked up and was doing a transmitter  calibration and it started beeping. Now it will not link to GSC. I only get two bars on the TX RX  meter tried to do a up date and it times out. Do you think the FC IS fried

[hwh]

This is the third thread you've created with the same question. Merged with other two threads.

[myflyer]

Ok new at this

[myflyer]

I found the problem one of the pins on the receiver came loose installed a new one problem fixed thanks guys