[hugges]

Hi i have been using a cc3d board now i have changed to a banggood revo board but i cannot get my head around ppm or pwm im using a jr 2.4ghz with corona reciver they both worked fine with the cc3d  but now the revo board will not work the corona reciver on ppm all so i was setting up the revo board a picture the revo board came up for me to put inputs of flexi port imputs and ppm or pwm to the reciver port but how that came up im at a loss any help please

[nitromethane]

If I understand correctly you don't know how to connect a PPM or PWM receiver to the revo.

This should make things more clear: https://librepilot.atlassian.net/wiki/display/LPDOC/Revolution+Configuration

Connect them to the Receiver port also known as FlexIO (not Flexi)
If using PPM just connect the signal pin to the 5th pin from the left or if using PWM connect 6 channels in order to pins 5 to 10.
Power is on pins 1(GND) and 2(+5V).

Also, I really had a hard time understanding what you wrote (try including some punctuation, give the text some structure and pictures really say a lot more than a compact bit of text)

[hugges]

Thank you for your help an kind comments
I now have it flying ,whether it flying as it should i dont know time will tell

[Luis Mateus]

 I have the same problem. Can't get the board to recognize the input.
 I'm using one FS-TH9X, i've tried PPM and PWM with the same result, no input at all, no bars moving on manual and no throtle movement on wizard.

 To start identify the problem i've cheked the receiver with one servo and all the chanels are working fine.
 Try it again... problem remains...
 Could it be some firmeware issues...
 So by now my hair is turning grey.
 Set up: Nigth hawk 200;multistar elite 2204 2300KV;Litlebee 20A OPTO;Mini PDB;RevoLUTION with OPlink.

 Any help is very much welcome
 

[f5soh]

Hi Luis, welcome.

Which receiver do you use ?
Better start with PPM input, less wires.

Post a picture how you wired the receiver and your config file. File > Export UAV settings.

[Luis Mateus]

 Thank you for respond in so short notice.

[f5soh]

Are you sure this receiver can output a PPM signal ?
http://www.rcgroups.com/forums/showthread.php?t=1416211

Modified thread title

[Luis Mateus]

 No sir, i'm not sure. But if i plug in a servo it works as it should on every chanel, so as far as i can understand it should also work fine as pwm right?

[f5soh]

Yes, only output PWM

Connect as PWM and set the Receiver to PWM in Hardware tab.
Disconnect board and remove all power
This is needed to apply all changes done in Hardware tab.

Connect again
Without any calibration you can monitor the receiver activity, go to the System tab and search for ReceiverActivity in UAVOBrowser:
Be sure the receiver is powered, this need external +5v



Moving a stick should display changes with Type: PWM and input number.

[Luis Mateus]

 Thank you sir. I'm gonna try it again and then let you now how it worked.

 And thank you once more for sharing your time and knolege.

[Luis Mateus]

 It's alive.

 Working properly.

 Next step...  tune up.

 Maybe in order to first race ever in Braga-Portugal 23th/24th.
 Cheers.



 

[f5soh]

Great

Enjoy