« previous next »
Pages: [1]
*

Ractive

  • *
  • 6
I messed up Revo Nano
« on: March 05, 2016, 02:45:26 pm »
In an attempt to get the OSD connected via bluetooth I think I have messed up as I can't now connect with USB

I changed USB HID port to VCP and selected Combridge
then set flexi port to combridge and set baud rate to 57600 (bt board was previously set to 57600)

rebooted and the GCS crashed, so restarted and now I can't connect via USB or bluetooth

any ideas - firstly how to get USB working again
and them the correct procedure to get BT working on the Nano
Logged
*

TheOtherCliff

  • *****
  • 4304
Re: I messed up Revo Nano
« Reply #1 on: March 05, 2016, 06:52:14 pm »
If you unplug OSD and still can't connect Nano to GCS via USB then you should probably erase settings and start over.

Unplug USB
go to GCS -> Firmware
press Rescue button
plug in USB to Nano
do what you need to, in your case, erase settings
Logged
*

Ractive

  • *
  • 6
Re: I messed up Revo Nano
« Reply #2 on: March 08, 2016, 04:10:50 pm »
Thank you - that did the trick
Logged
Pages: [1]
« previous next »