[annabell007007]

hi, first time using this, when I take off, it doesn't some 2 have the quick take off, like the open pilot, am using 2480kv,and 12 a esc,but am using a power board, which on my other drone, I just soldered all the wires 2 gather, and it went like shit off a shovel,any help,will be much appecheated ,sorry about the spelling,i have trouble writing,thanks am using the cc3d,and a 3s 2.2

[jbarchuk]

Triple check that...

Motors are turning in the correct direction as shown in the vehicle setup screens.

Props are facing the right direction, letters facing up, convex side facing up.

If they're both right try the motor neutral calibration again.

[annabell007007]

i will try a gain,thanks,just 1 question, the esc x4,,,seem 2 make a lot of beeps, like it might go on 4 20 secs,when setting up,and they just repeat them selves,,am confused,

[jbarchuk]

Those symptoms are obviously unusual but nothing I have any experience with. I'd try the ESC and motor calibration again, and do them individually not all at the same time.

[cato]

Check if the motor of the ESC which makes problem rotates at all. I had ESCs starting to contuously beep with BLHeli, I never checked what's the reason for the beeps, but I solved the issue by changing the BEC, the old one did not produce sufficient power for the FC.

[annabell007007]

these esc:s  don't have bec

[cato]

you need a BEC to power the Flight Controller. Sometimes this is included to the Power Distribution Board, some people prefer to always use a seperate BEC. To my experience, ESC integrated BECs do not work well. The one isse which I would check is your beeping ESC, there is certainly something wrong with it and you need to find out what it is. To my experience if an ESC behaves different to the rest, the quad will not be able to take off. I had ESCs which were broken from the beginning, and I had a PDB BEC which broke after only five minutes, so it may be a good idea to check those points.