[Sid]

Hello everybody
I'm trying to have telemetry reading on my up to date radio and I just can not find where the A1 and A2
are in the list and is not just there. I've watched a few videos how to set it up and on the video shows where
they are located but mine does not have it. I have tried with the receiver on or off but no success.
What am I doing wrong?
Thank you
Sid

Here is a screenshot of the Telemetry page.

[Sid]

I finally figured it out. I had to sit down and spend hours to setup my radio to order to read Telemetry. I found out there
are a lot of stuff that you just can not do by using Open TX software and it has to be done by the radio only. All I had to do
was  to go to Telemetry setup page and look for discover new sensors and that was it. It would change the screen for you
and now you have A1 and A2 listings.
Unfortunately there are so many different updates that affects the way the set ups run. Any sources out there is either too old
or different than what you're dealing with at the moment.