[Parris]

After a few days of chasing down a bounce before returning to level after a flip problem . And, with the help of , TheOtherCliff and f5soh , I have come to a conclusion . The problem is the way I use my transmitters in flight . Not necessarily my settings on my CC3D boards . The transmitters I have been using are the Flysky FS-i6 , Flysky FS-i6X and the Hisky X-6S . A quick release to neutral on the sticks always go past neutral in the other direction briefly . So , my bounce in flight is actually a bounce in my sticks . My CC3D boards are doing everything I have ever asked from them .

[TheOtherCliff]

I think the sticks are a lot faster bouncing than the quad is and so it is not the cause. 

Furthermore, if you release the stick sooner and let it bounce, the quad does not bounce.  If you wait too long the quad is rotating at full speed as it approaches level instead of slowing down as it approaches level.

[Parris]

Pilot error , I guess . All I know for sure is that when I flip and let the stick snap loose , in either pitch or roll , the craft basically stops leveling around 10 degrees before returning to level , on either axis . When I keep my thumb on the stick and manually , quickly , return to neutral , I don't have that 10 degree lag problem , I visually level it out .

[Parris]

Maybe it's time for me to start flying in Rate Mode . I don't know............

Thanks TheOtherCliff .


                                                                      Parris

[hexamann02]

Maybe it's time for me to start flying in Rate Mode . I don't know............

Thanks TheOtherCliff .


                                                                      Parris

Two words, Betaflight, or maybe that's one! Big difference!


Sent from my Moto E (4) Plus using Tapatalk

[hexamann02]

Maybe it's time for me to start flying in Rate Mode . I don't know............

Thanks TheOtherCliff .


                                                                      Parris

Two words, Betaflight, or maybe that's one! Big difference!


Sent from my Moto E (4) Plus using Tapatalk

Oh, I should mention, dump the cc3d flight controller, and install an f3 board.


Sent from my Moto E (4) Plus using Tapatalk