[Bubbasan]

Hi guys. Just got my first fpv ship and trying to set it up. I got a rise rxs225, manual says it uses the ccd3 board and librepilot.

Trying to set up a jeti ex r3 receiver via ex bus. No having any luck in having the librepilot software recognize any input from my transmitter.  I have the Rx set up to exbus output thru device explorer. I even tried setting the rx to output ppm positive and negative with no tx inputs recognized. Librepilot shows the rx and tx connected but can't calibrate as there is no recognized signal.

Any help would be appreciated.

[m_thread]

I am using EX.Bus on LibrePilot (i was actually the one who implemented it in firmware) and I haven't had any issues.
- Did you reboot your board after changing the receiver type in the Hardware configuration page?
- Did you connect the cables to the correct output on the R3, and did you check that the rx and tx was correctly connected to the board?
- Did you use the correct port on the CC3D, only flexi port is supported for EX.Bus?


Regards
/Fredrik