[Brunosanta]

I have a question, I burned my revo (radio part, oplink) now I need to use a Hobbyking 6 channels PWM receiver for the moment and I also use it on my CC3d, then a curious question, is it possible to use one shot with it? I see in hardware you have the option PWN + no oneshot but If I go to the motors tab later I can change it to oneshot anyway, would it work? thank you for the help mates.

[f5soh]

CC3D do not support Oneshot output using PWM input.

You can set the output as Oneshot but only get an alarm.

[Brunosanta]

Correct I get the alarm, but my escs really get into oneshot, I know cause I use the kingkong it jitters wen oneshot activated, the problem is that the software locks my throttle control. I tested it just yesterday. I wish I could use the oneshot and pwm, it would make my life easier! thank you anyway

[f5soh]

I wish I could use the oneshot and pwm, it would make my life easier! thank you anyway

If oneShot is not allowed using PWM at same time, there is a reason. You are warned.

[ima zman]

I too use CC3D with oneshot capable ESCs and a Walkera Devo 7 and PWM receiver...my FPVflys great.  However,  I want to switch to a PPM receiver but I believe i need to also get a different transmitter other than the Devo 7.  Can anyone suggest an inexpensive transmitter and receiver combo for PPM.

[NicholasDavid]

Get a Taranis and D4r or x4r-sb. D4r is ppm and x4r is sbus. I've got 4 up flying in quads. All work flawless and sbus is easy and simple.  200$-240$. It is a great value. Love mine.

[Zallestial]

I didn't have PPM on my reciever either so I got these to run oneshot on my CC3D and revo nano.
http://www.goodluckbuy.com/atmel-atmega328p-avr-ppm-encoder-v1-0-version-for-rc-model.html

[ima zman]

Thanks i now have three options... the taranis w dr4, the pwm to ppm encoder, and i believe the rx703. 
  Im thinking i will try the rx703 first, then the encoder, and last buying the taranis w dr4.
Anyone else use a Walkera Devo 7 with a rx703 PPM receiver?

[altermac]

If you are on the small budget side, then try Flysky / Turnigy i6 with ia6b-Receiver. The ia6b receiver is PPM capable and you get the complete set for about 50$. The ia6-Receiver is pwm only, so choose the set with ia6b or get one extra. Turnigy is a Hobbyking-Brand, Flysky is the manufacturer.

[kennyevo]

If you are on the small budget side, then try Flysky / Turnigy i6 with ia6b-Receiver. The ia6b receiver is PPM capable and you get the complete set for about 50$. The ia6-Receiver is pwm only, so choose the set with ia6b or get one extra. Turnigy is a Hobbyking-Brand, Flysky is the manufacturer.

I have a flysky fs-i6 with the ia6b receiver, I have 10 channels with an arduino pro mini and i-bus.

https://github.com/benb0jangles/FlySky-i6-Mod-

[jtrout19]

You could always purchase a replacement RF module and replace the one you burned out.