[Marduk2004]

Does anybody know, how to Connect a Retract PWM Signal to the Sparky 2, for switch with AUX1 or 2?

[f5soh]

For Sparky2 or any board you can affect a switch to one output, like for a buzzer:
https://librepilot.atlassian.net/wiki/display/LPDOC/Adding+a+buzzer+to+Multirotor+frame

You may take a look at the last column "Response Time" for the Accessory mapped with your switch, can be useful for gear.

[Marduk2004]

The Problem is, i used all 6 Output's for a Hexa. Is there any Option to use the LED Out's?

[f5soh]

7 to 10 are on Led connector

Because buffered you cannot use directly the output signal for servo.
Adding a pullup resistor give a PWM signal but inverted.

Solution can be add a small wire connected before the N-Fet, connected to a servo connector attached to board with hot glue or similar.


https://github.com/TauLabs/TauLabs/wiki/Sparky2#using-buffered-pwm-outputs

[Marduk2004]

Is Channel 7 to 10 supported in the RC1? I try to use the PWM Signal before the N-Fet, but it doesen't work. I set the right RC Input to the right Channel in Output...

[f5soh]

The LED output port works, you should pick the signal just before the mosfets for normal PWM output use.

[Marduk2004]

Ok Thank you, it work's yet. There was a problem with the Neutral in the Output Tab

[mookie]

Just a quick comment about the NFETS on an HK Sparky 2.

I have 3 originals but cant seem to get them any more so i went down the HK road and have found that the 2 nfets are only connected on 9 & 7 on the above diagram with the board that i bought from HK.

I was testing an inverter board that i made, works fine with the original but not with HK thats when i started to do a little digging.

So looks like i'll be making my own sparky 2's from now on. If any one is interested in using 7-10 ch on sparky 2 let me know.