Hi
I've troubles to get my quad to hover. So far
have mounted open cc3d, esc, receiver, soldering etc. and wanted to do some basic hovering but my quad constantly flips over and i do not know why?
I've got CW CCW
CCW CW - quad X config
Where CW are R (pusher) props
Can ESC be a problem ? (see screenshot) - i can't calibrate them under one close value so difference is about 150 units
Also can ESC placement near cc3d board be an issue? (esc are in front of cc3d board and on top of it there is pdb)
Quad parts: PFG frame (salvage from eox frame), opencc3d, dys1306 motors and Emax Simonk Series 12A)