Roll wont work in transmitter setup

Started by elind

Roll/pitch movement after punch out

Started by emperorsgroove

Rotate CC3D board 90*

Started by bcane98

Rotors don't move despite of armed and throttle

Started by mikmas

Saving a setup ?

Started by filo

Saving Advanced Settings - Doesn't work :(

Started by rahduke

SBUS/GPS RevoLUTION

Started by Anibalch

SE motor not responding

Started by yashuone

seeking some clarification on yaw

Started by Libra pilot

Self-level FPV camera AND manual control

Started by Maverick9D

Send Quad copter control signals from Arduino or R PI to receiver on OPilot CC3d

Started by anshulkatta

Sensor Calibration

Started by Ben « 1 2 »

Set my "gear" switch to start the motors

Started by juckeyy

Set up cc3d/rx tx NO throttle???

Started by Ryan8828

Setting home location using GCS MAP

Started by startrek66

Setting homelocation

Started by anthropo

Setting PPM+OneShot Pin8

Started by Belko « 1 2 3 4 »

Setting up DX8 xm to use rotating knob as TX PID input

Started by weepop

Setting up flight mode switch on Turnigy 9x

Started by hamilc

Setting up revolution for a relay switch

Started by Jackbear « 1 2 »