LibrePilot Forum

Users => Applications - FPV => Topic started by: mpopa on February 28, 2016, 02:41:02 pm

Title: CC3D+OPLINK+minoposd - possible?
Post by: mpopa on February 28, 2016, 02:41:02 pm

Hi,

Is there a working setup in which:
- CC3D Main -> Telemetry to OPLINK Main, CC3D Flexi to DSMx
- OPLINK Flexi to minoposd

I was able to have working either oplink telemetry or osd telemetry (minimosd connected directly in CC3D), but I cannot make them work at the same time. I do know that CC3D supports only one telemetry connection at a time but I was under the impression that OPLINK is capable of handling this setup.
Am I doing something wrong or it's just plain impossible?

Thanks,
Marius

Title: Re: CC3D+OPLINK+minoposd - possible?
Post by: f5soh on February 28, 2016, 07:24:00 pm

Hi,

For what i know the Oplink cannot duplicate telemetry input from his MainPort to FlexiPort.

Maybe simply connect the Rx pin from OSD to the wire between CC3D MainPort (Tx pin) and Oplm (Rx pin) ? Never tested.

Laurent

Title: Re: CC3D+OPLINK+minoposd - possible?
Post by: TheOtherCliff on March 02, 2016, 09:52:30 pm

I recall that the only problem with that setup is that OSD stops updating if you fly out of range of OPLink.

The way to fix that would be to make the air OPLink the coordinator.