LibrePilot Forum
General Category => General Discussion => Topic started by: k_h_d on February 26, 2016, 05:29:52 pm
-
I am following the directions on the following page to map a buzzer to one of the outputs on my CC3D board.
https://librepilot.atlassian.net/wiki/display/LPDOC/Adding+a+buzzer+to+Multirotor+frame
I have the buzzer plugged into the #5 slot on the CC3D board.
I have the switch on my transmitter working Accessory1 on the RC Input page.
On the Vehicle setup I have Accessory one RC input Mapped to RC Output Channel 5.
Then when I go to the output page to try and set the min value to 1000, middle to 1500, and max to 2000 I can't change the value on bank 5. The slider is gray and I can't select anything.
Any ideas?
-
Forgot to add, right now the buzzer just goes off constantly like the switch is always activated.
-
Can you attach some screenshots?
The Input, Vehicle and Output ones will do!
-
Will do! Thanks! I'll post them Sunday.
-
Screen shots.
-
Hi there,
A few things: For the Buzzer problem you´ve got to set the Output Channel Number 5 Max to 2000, then you can change your Channel Neutral to 1500 and the Buzzer should work....
...BUT You should re-run your transmitter Wizzard!! Every input channel has its EndPoints and Mid Values wrong. Hit "Start Transmitter Setup Wizzard" or Ctrl+t. What Radio are you using? Did you follow the instructions on the Transmitter Wizzard the first time?
-
I was manually trying to enter 1500 into the output page for neutral setting and it requires you to move the slider. Now it works. Thanks!