LibrePilot Forum
General Category => General Discussion => Topic started by: rmsingh256 on February 15, 2016, 10:00:44 pm
-
Hi all,
I'm a new member and is seeking some assistance.
I have an Eachine 250 Racer and have decided to move to Librepilot from OpenPilot.
I'm having an issue when using LP GCS to configure the CC3D FC.
I can flash the firmware (bu_cc3d.opfw) using the rescue method via USB, but GCS will not show the FC at all in the drop down list whenever I try to 'Upgrade' using the Vehicle Setup Wizard.
See attached screen shots. I appreciate any help.
-
Hi, welcome.
Try reinstalling windows driver ?
https://librepilot.atlassian.net/wiki/display/LPDOC/Troubleshooting
-
Thanks for your help. I tried but it did not work.
I followed the steps and Windows 10 detected the FC as 'Copter Control' and installed the driver. However LP GCS is still timing out when trying to upgrade.
Any other suggestions?
-
The led are blinking fast after you apply power ?
-
I don't think so. Green LED is solid, Blue LED is blinking once per sec.
-
If fading in/out slowly you need to flash firmware.
(https://librepilot.atlassian.net/wiki/download/attachments/5669026/CC3D_bootloadermode.gif)
- Disconnect board
- Hit Upgrade&Erase button
- Connect board
- Wait until the board remain connected (maybe 30seconds after flashing finished)
-
Wow, that worked. Still don't know what I was doing wrong. I thought I did that at least 10 times :o.
Thanks for you help.
-
The normal firmware (Connect board and next Upgrade&Erase button) update works only if a firmware is already running and board connected.
After a bootloader update the only way to update firwmare is hit Upgrade&Erase button before connecting board.
-
I see it now, good to know.
Thanks