LibrePilot Forum
General Category => General Discussion => Topic started by: Jeuke26 on February 06, 2016, 11:53:32 am
-
This is my 5th cc3d setup but this one gives me headaches.
I have a normal cc3d and using DYS BLHeli ESC on 4S.
When starting configuration wizard in the motor output tab. Hitting start gives this error: "actuator module error".
Eh?
-
Post your current UAV config: Help > Export UAV data...
Did you Upgrade&Erase board prior to Wizard ?
-
No, I only hit upgrade in the firmware tab. Furthermore the error message said " this can be because there are no Inputs"
I'll post the settings you ask when I'm back home.
-
Got it to work after couple of reflashing the board and erasing all settings. Thanks for pointing in the direction of software. I was scared it was a hardware failure.